Brstjjy

Chess set with timer

A time control is a mechanism in the tournament play of almost all two-player board games so that each round of the match can finish in a timely way and the tournament can proceed. Time controls are typically enforced by means of a game clock. Time pressure (or time trouble or zeitnot) is the situation of having very little time on a player's clock to complete their remaining moves.

In the case of chess, the World Chess Federation FIDE has a single, classical time control for most of its major events, 90 minutes for the first 40 moves, followed by 30 minutes for the rest of the game, with an addition of 30 seconds per move starting from move one.^[1] The Candidates tournament and the World Championship are currently played at 100 minutes for 40 moves, followed by 50 minutes for 20 moves, followed by 15 minutes for the rest of the game, with a 30-second increment starting from move one. Also, FIDE formulates different time controls for fast chess.^[2]

Classification

The amount of time given to each player to complete their moves will vary from game to game.
However most games tend to change the classification of tournaments according to the length of
time given to the players.^[3] Shorter time limits, which do not afford due consideration to moves, are afforded a lesser degree of importance. Indeed, shorter limits are normally given special names to distinguish them.

In chess, the categories of short time limits are: 'lightning', 'bullet', 'blitz', and 'rapid'.
'Bullet' or 'Lightning' games are the fastest, with either a very short time limit per move (such as ten seconds) or a very short total time (such as one or two minutes).
'Blitz' games typically give five to ten minutes per player, and 'rapid' games give between ten and sixty minutes.
By way of contrast, for Go anything under twenty minutes could be considered blitz.

Methodology

The exact approach to using a game clock to regulate games varies considerably.

Sudden death

This is the simplest methodology. Each player is assigned a fixed amount of time for the whole game: once a player's main time expires, they lose the game.

Hourglass

Each player's clock starts with a specified time (e.g. 1 minute, 10 min etc.). While Player 1 is deciding a move, player 1's clock time is decreasing and Player 2's clock time is increasing. This is similar to how an hourglass works; sand empties from one container and fills into the other. Moving slowly gives your opponent extra time. The sum of both clocks will always remain the same. There is no maximum amount of time allotted for a game with this timing method; as long as both players play quickly, the game will continue until its natural end. When time runs out on one player's clock the game is over and that player loses. Use of this time control is uncommon.

Overtime formats

Here the game time is separated into two basic domains: the main time, and the overtime. To switch between the two requires some trigger event. Often this is the expiration of the main time. In chess, reaching a fixed number of moves can trigger the gain of a fixed amount of bonus time. This is the general chess rule and it usually occurs in long games after the 40th move:
e.g. 120 minutes to complete the first 40 moves, and another 30 minutes to complete the entire game.

In go two common forms are:

Japanese byo-yomi

Byo-yomi (秒読み, byōyomi) is an extended time control in two-player games, specifically shogi and go. The word is borrowed from Japanese; the term literally means "counting the seconds", or more generally, "countdown".

After the main time is depleted, a player has a certain number of periods (for example five periods, each of thirty seconds). If a move is completed before the time expires, the time period resets and restarts the next turn. If a move is not completed within a time period, the time period will expire, and the next time period begins. This is written as <maintime> + <number of byo-yomi time periods> of <byo-yomi time period>. Using up the last period means that the player has lost on time. In some systems, such as certain Go title matches, there is no main time; instead, the time used is rounded down to the nearest whole increment, such as one minute, and the actual counting of time occurs toward the end of one player's time.

A typical time control is "60 minutes + 30 seconds byo-yomi", which means that each player may make as many or as few moves as he chooses during his first 60 minutes of thinking time, but after the hour is exhausted, he must make each move in thirty seconds or less. To enforce byo-yomi, a third person or a game clock with a byo-yomi option is necessary.

In professional Go games and many amateur tournaments, a player has several byo-yomi periods, for example five periods of one minute each. If a player makes his move within a one-minute period, he retains all five periods for his future moves. If a player oversteps one minute, he starts the following move in the second rather than the first byo-yomi period. In effect, the player has one minute per move plus four extra one-minute packets which may be used as needed, e.g. four moves of two minutes each, or one move of five minutes, or any other combination.

In higher-level tournaments, such as the Kisei tournament, the player's time is often composed entirely of byo-yomi periods (for example, in an eight-hour game, the player may have 480 periods of one minute each), rather than having a main block of thinking time. In this case, the actual counting of time (verbally) begins once the player falls below a certain threshold of time, such as 10 minutes; when the time is being counted, the player is informed at intervals how much time they have used in their current period, and how many extra periods they have left. (For example, the time may be called at 10-second intervals, and when 55 and 58 seconds have been used; during a player's final minute, the last 10 seconds are counted one by one.) ^[4] Similarly, in the televised NHK Cup tournament, the player has 30 seconds per move plus 10 extra one-minute periods which may be used as needed.

When analog game clocks are used to enforce byo-yomi, it is more convenient to assign additional time for a block of moves, rather than for each move. In Canadian byo-yomi, a player typically gets 5 minutes for 10 to 20 moves. The IGS Go server uses a similar system, but the byo-yomi time is variable and always covers 25 moves. Thus the time control "20 minutes + 15 minutes byoyomi" on IGS means that after the initial 20 minutes of thinking time are over, a player is granted 15 additional minutes, which may be spent however he chooses. If these minutes expire before he has made 25 more moves, he loses. If he makes 25 more moves in less than 15 minutes, he is granted another 15 minutes of byo-yomi, and so on indefinitely.

Canadian byo-yomi imposes a certain average speed of play, but allows the player to spend more time to ponder on difficult moves. Several byo-yomi periods in one move per period variant (also known as Japanese byo-yomi, though that is a bit of tautology) serve essentially the same purpose, albeit to a lesser extent.

Unused time during one byo-yomi period does not carry forward to future moves. This is in contrast to the Fischer clock often used in chess, with designations such as "5 minutes + 12 seconds per move". Under this time control each player has twelve seconds added to his clock after every move, starting from the first move, regardless of how much time he spends on each move. Thus if a player thinks for eight seconds before making his first move, he will have five minutes and four seconds on his clock after making it.

Canadian overtime

After using all of his/her main time, a player must make a certain number of moves within a certain period of time — for example, twenty moves within five minutes. In Go, players stop the clock, and the player in overtime counts out the required number of stones and sets the remaining stones out of reach so as not to become confused, whilst the opponent sets the clock to the overtime period. If all the moves are made in time, then another period of overtime starts — another set of stones and the timer again reset to the overtime period. If all the moves are not made in time, the player has lost on time. This is written as <main time> + <number of moves to be completed in each time period> in <time period>.^[5] In Progressive Canadian Overtime the required rate of play alters in additional overtime periods — EG 1hour + 10 in 5, 20 in 5, 30 in 5, 40 in 5 etc.^[6]

Compensation (increment or delay methods)

Increment (also known as Fischer and bonus)—a specified amount of time is added for each move. For example, if the increment is thirty seconds, each player gets an additional thirty seconds for each move. Under FIDE and US Chess rules you get the increment for move one as well. For example, for G/3;inc2 (three minutes of base time with a two-second increment each move), you start with three minutes and two seconds on the first move. Not all digital chess clocks automatically give the increment for move one and thus for those that don't, the increment time has to be added manually to be base time so each player gets the increment for move one.

Bronstein delay—this timing method adds time but unlike increment not always the maximum amount of time is added. If a player expends more than the specified delay, then the entire delay is added to the player's clock but if a player moves faster than the delay, only the exact amount of time expended by the player is added. For example, if the delay is ten seconds and a player uses ten or more seconds for a move, ten seconds is added after they complete their move. If the player uses five seconds for a move, five seconds is added after they complete their move. This ensures that the base time left on the clock can never increase even if a player makes fast moves. As with increment, you get the delay time for move one under FIDE and US Chess rules.

Simple delay (also known as countdown delay and US delay)—with this timing method, the clock waits for the delay period each move before starting to subtract the player's base time. For example, if the delay is ten seconds, the clock waits for ten seconds each move before the base time starts going down. This timing method is mathematically equivalent to Bronstein delay. Simple delay is the form of delay most often used in the US while Bronstein delay is the form of delay most often used in most other countries.

Penalty formats

Such methods exact a points penalty, or fine, on the player who breaches their time limit. One example occurs in Go, where the Ing Rules enforce fines on breaches of main time and overtime periods.^[7] In tournament Scrabble, the time control is standardized to 25 minutes per side with a 10-point penalty for each minute or part thereof that is used in excess,^[8] so that overstepping the allotted time by 61 seconds carries a 20-point penalty. In chess, a person will automatically lose if they lose their game on time unless they try a draw claim. (See Rule 14-H in the USCF manual for chess).

Usage on chess servers

On chess servers (like Internet Chess Club and Free Internet Chess Server) the time control is usually expressed with a formula: time+increment. Where time is a fixed amount of time (in minutes) assigned at move 0 for the entire game, and increment (in seconds) is the amount added after each move.

A game can even have a time set to 0: the clock is set to 0 and started after the first move with the increment only on both sides, and each move each player is granted only the increment: a 0+10 is a game where after the first move each player has 10 seconds to move.

See also

Book: Go: The Board Game

• Time trouble


• Rules of chess


• Fast chess


• Shot clock


• Time limit (video game terminology)


• International Go Federation


• List of professional Go tournaments

References

External links

• FIDE Tournament Time Control rule


• US Patent No. 4,884,255 for Fischer's clock


• Game time controls on BrainKing


• 
  A sudden death time control determines the 2008 U.S. Women's Chess Championship


• 
  Sensei’s Library definition of byo-yomi.


• 
  British Go Association description of how time is called.